rreegg
Full Access Member
Gonna roll with the bushing that came with the used bracket, they seem minimally worn and things are greased up nicely.
What’s the best way to remove the clutch master cylinder rod pin? Remember when doing the heim joint before there were instructions and maybe there being two different methods, year dependent. Need to reattach this to a heim that’s already on the master cyl
Grind down flush the domed rivet and then punch? Or cut off the pin/post side and then punch?
What’s the best way to remove the clutch master cylinder rod pin? Remember when doing the heim joint before there were instructions and maybe there being two different methods, year dependent. Need to reattach this to a heim that’s already on the master cyl
Grind down flush the domed rivet and then punch? Or cut off the pin/post side and then punch?