It's been a while since I've updated this thread so here's where things are because I think I'm going to be using it in the next week or so. Fingers crossed.
I ran my air line in.
You must be registered for see images attach
So I have a refrigerated dryer that comes from the compressor. I'll connect it to the block outside (left) and connect my inside hose to the regulator, oil/water separator. I'm contemplating a real particulate filter as well. This will be dedicated to paint work only as will the new hose I'll pick up this weekend.
I got the J channel up for the filters.
You must be registered for see images attach
Stuck a filter in for a test fit.
You must be registered for see images attach
It's a little snug but I don't think that's a bad thing.
I spray foamed all the big holes. I may caulk the cracks. Not sure yet. Before using it, I'll vacuum the walls and ceiling, hose the floor then blow everything throughly with air and the fan on. That's about all I can think to do.
Need to make 2 more stringers and then put a few nuts and washers on and it will be good to go. It's going to be very snug but I think it will be workable.