You must be registered for see images attach
For the first time since late 2011, early 2012 when I did my zf swap I have reverse lights. Added couple 500 lumen work lights an they make a world of difference. No tail gated switch yet, just tied to the reverse light circuit. Autozone used to sell the correct plug just a matter of months ago, recently tried to buy one and they said it's no longer available. I read on here some scuttlebutt about using a windshield washer pump connector. Well if any ones held that connector up to the switch knows it's too wide. Wish I had taken a pic but to make it work I cut with a razor blade pretty much the center section out along the retainers to where I had two separate terminals, approximately the center 1/2" or little under. Those then fit the reverse light switch snugly and to keep them there I used heat shrink to keep them from backing out. Maybe latter I'll add a weather PAC connector to beable to unplug the switch but for now it's hard wired to the e4od harness I trimmed down. Used a 7/8 sensor socket to install switch.