hacked89
Full Access Member
This is without putting a new sleeve.
I’ll update a future video with the sleeve process.
I’ll update a future video with the sleeve process.
xc_hide_links_from_guests_guests_error_hide_media
Thanks Goat let me know how it goes. I haven’t had to remove a sleeve yet. I’d probably do the iffy way very carefully if I couldn’t find a better way.Great video you posted. Best one on YT.
I did pick up a Rotunda Seal installer tool off e-bay like this one. T83T-6701-A
Ford T83T-6701-A OTC Rotunda Rear Crankshaft Oil Seal Installer | eBay
Ford T83T-6701-A OTC Rotunda Rear Crankshaft Oil Seal Installer. Condition is Used. Shipped with USPS Ground Advantage.www.ebay.com
It looks like your Crank Flange has the Speedy Sleeve on it.
I pulled my rear cover off today, and looks like I have one also. Run my finger across it and feel a slight depression.
Been reading various threads on removing them. Some say to grind across the sleeve etc... kind of iffy doing it that way
Found a couple YT Vids that are pretty slick.
xc_hide_links_from_guests_guests_error_hide_media
xc_hide_links_from_guests_guests_error_hide_media
Not much room under the truck with the pan in the way and not much room to swing a hammer and chisel
How do you remove them safely?
I have a Felpro seal and speedy Sleeve I picked up at O`Reilly`s. Been searching for a Seal compatible with installing a Sleeve. Don`t see anything listed.
Found a part# F2TZ-6701-A on the FTE Forum, but discontinued from Ford. Ford Parts Giant and one dealer in Texas has one in stock. $51 and $73.
Suppose to have the tool, plastic sleeve to protect the gasket etc...
See if I can assemble the press tool you posted, clean the plate and press in the new seal tomorrow...we`lll see.
Goat