Search results

  1. R

    Pump question

    I have a stanedyne pump on a john deer 4045, same as an idi pump but set up for a 4 cylinder the other day it blew the the fuel screw access plate off the side of the pump, snapped the screws. It still ran but obviously pumped out fuel like crazy. any ideas on the cause? Sent from my SM-N986U...
  2. R

    6.0 vs 6.4 in an IH truck

    Looking at a pair of trucks one is a 2006 IH with a 6.0, the other is a 2009 IH with a 6.4, both have similar miles and hours, witch is the greater evil?? Sent from my SM-G965U using Tapatalk
  3. R

    Better air filter

    Ok now I have my chip reburn along with baby swamps and wicked wheel, needless to say the truck is a beast, boost needle goes straight to 30lbs the filter minder pegs out totally, I already have a 6637 filter is there a better setup that still uses a paper filter? I am very suspicious of...
  4. R

    new goodies

    So I just got done with: new injectors (baby swamps) driven diesel e-fuel system wicked wheel ebpv delete Unfortunately my reburned chip hasn't made it here yet, but with no chip I think it has more power than it did with the old stuff and the 50 hp chip I had. The new compressor wheel has a...
  5. R

    Stuttering throttle

    This truck has had this problem for a long time but has gotten worse lately, during light throttle application and early in the drive cycle, its like your feathering the throttle but much faster than humanly possible. One upon a time I changed the TPS when the problem wasn't so bad and it...
  6. R

    How much power from a ve?

    Doing some homework on a possible swap, would like at least 350hp is this possible with a ve? or a modified aftermarket pump? or should I look into switching to a p-pump? Sent from my XT1650 using Tapatalk
  7. R

    97 needs more pep

    Its been a long time since I've done any upgrades to the old girl, right now it has a Wildman 6 pos. chip with the strongest position being 50 hp, its a total slug compared to the y2k. I think I need new injectors, it idles fine but almost seems to miss at high rpm/throttle. would like it if...
  8. R

    E4OD/4R100

    Is there a significant difference between the two? my 97 has had 4 trannies by 218000, the one thats in it is getting iffy, it doesn't tow anything very heavy and not often. By contrast my Y2K has 265000 on the factory 4R100, is programmed to as much power as I can get (+140hp) and tows a loaded...
  9. R

    Degas bottle

    I'm on my way back from Idaho with a dump truck box on my gooseneck, this is my first heavyish long distance haul with this truck in a long time and I seem to be having a problem keeping my coolant up to level, it was fine unloaded but now fighting a strong headwind its going though just enough...
  10. R

    Kenworth AG100 with a tank?

    The kenworth in my signature has the AG100 (8 bag) suspension and I'm trying to figure out if its wise to mount an unbaffeled tank (3000 gallon septic pumper) on this suspension or if I should change it to something else?
  11. R

    Climate control not working well

    The climate control in my 05 is not getting very warm, I've replaced the blend door actuator and when I did that I checked the action of the blend door itself witch seems to be fine. It does seem to react to opening a window or changing the desired temp but even set at 90* it might get to 67-8*...
  12. R

    6.0 oil temp

    I have a 05 f350 6.0, 22k ago I had the oil cooler and egr delete done, then about 10k later I figured I had a minor head gasket blow (loosing coolant out of the Degas when towing) at that time I had a edge monitor and my deltas were 20-30. Did the head gaskets and studs told the shop about the...
  13. R

    Cat c7 pto problems

    My big sweeper, 06 freightliner m2 w/cat c7/Allison 3500 has developed a very annoying problem that freightliner cant find, after the pto has been on for a bit (sweeping) the motor will start surging, as I know it the computer wants to give the motor 150 rpm when the pto is on, not specific to...
  14. R

    Cam sensor

    Recently my truck has hiccuped a few times and as my first rule with a PSD- do the CPS first when it does something funny. This time I got one from IH to replace the recall CPS that has been in the truck for a few years now, and I've got to say the IH sensor made a huge difference. It starts...
  15. R

    Mileage not what I think it should be..

    Last week I did a short trip (350 mi) that I've done many times before, the truck seems to run good, it has about 500 mi. on a oil change and a new 6637 a/f. I averaged 16.8, in the past I've done as well as 18.4 on the same trip, I always take this trip during non traffic hours and for the most...
  16. R

    Fuel tank idea

    Posting here because the crickets upstairs are pretty loud. Im replacing the rear tank in my psd because its leaking, and I made the observation that the front tank is 4" +- lower than the rear, with that in mind and gravity what it is could (or has) someone welded fittings on the tanks to...
  17. R

    Stupid f&&& tranny again!

    F- this POS I cant seem have one of these f-tardeds last more than 2k. Its been fine for months and the other day I back out of the driveway and shift to drive and it makes a whining noise and wont move unless I give it some gas, then if I baby it it has a lot of resistance (binding I assume)...
  18. R

    TPS problems

    For a while I've had a problem with a slight stutter at a certain throttle position, the other day I noticed it getting a little worse so today I got a new tps, installed it and now I have no throttle at all and the check engine light is now on, tried the old one and the same thing, what gives??
  19. R

    Cummins options??

    I seem to have the worst luck with e4ods:puke::puke::puke: the one I just put in is heading south and I DO NOT want another one of these in my truck, so these are my options: 1. keep the psd and convert to a zf5 (I dont like the zf6) 2. keep the psd and do a allison 1000 conversion 3. do...
  20. R

    ZF5 differences??

    Found a deal on a ZF5 from a 93-4 its 2wd, is it the same as a psd zf? what will it take to put a tcase behind it?
  21. R

    Trailer running lights not working??

    I pinched a marker light wire on my car trailer and now I have no marker power at the plug, I replaced the relay and pulled the plug and harness and checked for continuity and its not there, is there a secret fuse or a fusable link that I dont know about?
  22. R

    Gear oil-death stench

    I use a 100 gal. tank in the bed of my psd for mixing wmo and fueling the sweepers, the other day I must have gotten a little gear oil mixed in with #2, Im guessing about 2-3 gal mixed with 60 gal of #2 with a total mix of about 12% after adding other regular wmo. IT FRIGGIN...
  23. R

    Isuzu NPR info??

    I just bought another sweeper thats mounted on a npr chassis, its a 97 with the 3.9 and an auto trans, no problems right now but Im looking for a good place to troll for info on these. Thanks
  24. R

    WANTED: ZF5 FOR PSD

    For a 4wd if thers a difference, also needed all the rest of the goods for a conversion. PM me thanks -Russ
  25. R

    ZF bellhousing differences (gas vs.diesel)

    You IDIers are the most swap savvy bunch I know of so for this I come to you, recently I had a tranny guy tell me that the only difference between gas and diesel b-housings was the size of the bolt holes and perhaps the alignment studs, is this true?

Latest posts

Forum statistics

Threads
91,348
Posts
1,130,808
Members
24,148
Latest member
Alleycat

Members online

Total: 180 (members: 2, guests: 178)

Share this page

Top